1992 kawasaki ZZR 600 Owners Manuals, User Guides, Instructional Help Documents & Operating Information - zzr 600.pdf
Citation
Thank you for purchasing this Dynojet kit. This kit has been developed for a motorcycle which is set to the parameters listed at the right in the “Stage” description. If your motorcycle does not meet any of these parameters please check with Dynojet before installation. For technical assistance contact your Dynojet distributor or call Dynojet U.S.A. (800)-992-4993
WARNING E2142.001 European Models Only
2191 Mendenhall Dr. Suite 105 North Las Vegas, NV 89031 TEL: 702-399-1423 FAX: 702-399-1431 8am-5pm Pacific Time Monday through Friday
Website Address http://www.dynojet.com
NO SMOKING! NO OPEN FLAME! WHILE INSTALLING YOUR DYNOJET KIT
1990-92 Kawasaki ZZR600 Stage 1 For mildly tuned machines using the stock airbox, with stock or K&N filter. May also be used with a good aftermarket exhaust system K&N filter #KA-0013
The manufacturer and seller make no warranties express or implied which extend beyond the description of the goods contained herein. Any description of this product is for the purpose of identifying it and shall not be deemed to create an express warranty.
This graph shows a typical gain with a Dynojet jet kit.
Parts List 4
Main Jets
DJ136
4
Main Jets
DJ140
4 4
Main Jets Fuel Needles
DJ144 DNO228
8
Adjusting Washers
DW0001
4 1
E-clips Glue
DE0001 DA0001
4 1
Main Air Correctors Tool
DCO201 DT001
STAGE ONE INSTRUCTIONS E2142.001
1. Remove vacuum slide from carbs. Remove stock needles & spacers, noting order of assembly (Fig.A). 2. Install Dynojet needles on groove #4, using all stock spacers. Install the Dynojet washers above the E-clip (2 per needle).
Place E-clip in groove #4 from the top
3. Remove the stock main jets and replace with the Dynojet mains provided. If you are running the stock exhaust use the DJ140 main jets, if you are running an aftermarket header or slip-on with high flowing baffle, use the DJ144 main jets. Be sure that the jets you are changing are the main jets. 4. Locate the main air jet passage (Fig. B). With the flat end facing into the carb, install the main air correctors provided (DCO201). Use the tool provided (DT001) to tap lightly in place. With the glue provided, lightly touch a dab on the outer edge of the air corrector. Allow glue to dry.
Fig. B
Main Air Jet Passage
5. Locate the Fuel Mixture Screws (Fig. C). Carefully turn mixture screws clockwise until lightly seated, then turn out until you find your best idle. Our base setting is 3 turns.
Fig. A
Fig. C