Zippo Outdoor Line Utility Lighter

Outdoor Utility Lighter Attach strap ring Top flame (burner)

Fuel level indicator

Additional Information

• •

Protective cap

LED Flashlight

Bottom fuel adjustment / filling valve

LED Button

Like all butane lighters, this product will not perform well at an altitude of over 10,000 feet (3,000m). If you have any problems with the operation of your Outdoor Utility Lighter, do not return it to the store. Instead, contact Zippo for operating tips and repair instructions. For repairs, special shipping procedures apply (due to government regulations). Shipping information can be found on zippo.com or by contacting Zippo Consumer Relations at 814-368-2700. A $5.00 shipping and handling fee applies to repairs of the Outdoor Utility Lighter.

The ergonomic design of the Zippo Outdoor Utility Lighter features a patented child-resistant safety control button (A) which, when depressed, releases and allows the ignition button (B) to engage. Note that the Outdoor Utility Lighter is pre-filled with butane fuel. To operate: 1. Remove protective cap 2. Depress and hold safety control button (A) 3. Depress and hold the ignition button (B) to ignite and maintain flame 4. Release the ignition switch (B) to extinguish flame and stop fuel flow Caution: Hold the device upright until the flame is fully extinguished. Adjusting flame height: Rotate the knob counterclockwise (+ direction) to increase the flame height and clockwise (- direction) to reduce the flame height.

Any Zippo Outdoor Utility Lighter returned to our factory for warranty repair will be repaired free of charge or replaced, at our discretion. There is a $5.00 shipping and handling fee. Damage to the Outdoor Utility Lighter resulting from abuse or misuse is not covered by our warranty. The finish and the LED batteries are not warranted. This warranty gives you specific legal rights. You may also have other rights which vary state to state. Other Zippo products carry their own specific warranties. To obtain service under this warranty, refer to repair instructions at zippo.com or contact Consumer Relations at 814-368-2700. A  $5.00 shipping and handling fee applies to repairs of the Outdoor Utility Lighter. 1932 Zippo Dr. Bradford, PA 16701 U.S.A.

Fuel adjustment

knob Protective cap The cap is located at the top of the lighter. It protects the burner from contamination, debris, and moisture. To use the lighter, remove the cap. The cable tethers the cap to the lighter

Do not refill near flame, heat source or sparks. Use only in well ventilated area. To refill with butane fuel: 1. Use only a premium grade butane fuel to refill. Use of other than Zippo Premium Butane Fuel may result in damage to the filling valve and could cause clogging. Be sure to check level in the fuel indicator prior to refilling the lighter. 2. Always refill lighter as shown in figure (C) below. 3. Place butane fuel nozzle into filling valve and depress several times with firm, even pressure. 4. Wait at least two minutes after refueling before using. 5. Use caution when lighter is lit. Flame is extremely hot and a portion of it is invisible.

Filling valve

Handy Clip Your Outdoor Utility Lighter comes with a convenient clip and strap. Attach the strap with the metal ring.

This lighters is child resistant and complies with ASTM F2201-02e1 & ISO 22702:2003 Printed in China

LED Flashlight: Your new Outdoor Utility Lighter is equipped with a built in LED light source. The product is shipped with the battery tray for the LED light partially removed and an insulating tab in place. To activate your LED remove the tab and push the battery tray firmly into place. 1. To turn the flashlight on, push LED button once (see illustration at the top of page). 2. To turn the flashlight off, push button a second time.

Battery tray

To replace the batteries: 1. Using a fingernail or implement, remove the battery tray. 2. Replace the batteries (3) with NL #LR41, or equivalent, with the positive side facing up. 3. Firmly push the tray back into original position for LED to operate.