VTech Communications LS6475-3 Cordless Phone Answer Machine 2-Handsets

®

Quick start guide LS6475-2/LS6475-3/LS6476-4

Headset charging

Handset overview

After installing the telephone base, charge the headset as shown below. The headset is fully charged after three hours of continuous charging. If the light does not turn on while charging, you need to charge the headset without interruption for at least 15 minutes to give the headset enough charge to use for a short time.

CHARGE light On when the handset is charging.

1. Place the tip of the headset in the small cradle on the telephone base.

Introduction This quick start guide provides you with the basic installation and use instructions. A limited set of features are described in abbreviated form. Please refer to the user’s manual for complete installation and operation instructions.

Telephone base and charger installation

Electrical outlet not controlled by a wall switch

Electrical outlet not controlled by a wall switch If you have DSL high speed Internet service, a DSL filter (not included) is required.

Charger adapter

2. The magnet holds the top of the headset in place. The turns on when charging.

light

The

Telephone line cord

/ /VOLUME Review the directory when the telephone is not in use. Scroll up while in a menu. Increase the listening volume during a call or message playback. Move the cursor to the right when entering numbers or names in the directory.

MENU/SELECT Show the menu. Choose an item, or save an entry or setting while in a menu. PUSH TO TALK (PTT) Begin a one-to-one or one-to-group broadcast.

MUTE/DELETE Mute the microphone during a call. Delete the displayed entry while in the directory, caller ID log or redial list. Silence the ringer temporarily while the handset is ringing. Delete digits or characters while using the dialing keys.

Install the telephone base and charger as shown below. Telephone base Telephone power adapter wall jack

CID/ /VOLUME Review the caller ID log when the telephone is not in use. Scroll down while in a menu. Decrease the listening volume during a call or message playback. Move the cursor to the left when entering numbers or names in the directory.

light

OFF/CANCEL Hang up a call. Silence the ringer temporarily while the handset is ringing. Press and hold to delete the missed call indicator while the telephone is not in use. Press to return to the previous menu, or press and hold to return to idle mode without making changes.

/FLASH Make or answer a call. Answer a call waiting call during a call.

Dialing keys Enter numbers or characters.

1 Press repeatedly to add or remove 1 in front of the caller ID log entry before dialing or saving it to the directory.

# (pound key)

Switch to tone dialing temporarily while on a call. Telephone base

Charger

Handset battery installation and charging Install the battery as shown below. Once you have installed the battery, you may be able to make and receive short calls. For best performance, charge the handset battery continuously for at least 10 hours. 1. Plug the battery connector securely into the socket inside the handset battery compartment, matching the color-coded label.

2. Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment.

Telephone base overview IN USE light Flashes when there is an incoming call, or another telephone sharing the same line is in use. Flashes when the handsets/headsets are being deregistered. On when the phone is in use, or the answering system is answering a call. On when a handset/ headset is  being registered.

3. Slide the battery compartment cover towards the center of the handset until it clicks into place.

X/DELETE Delete the message currently playing. Press twice to delete all old messages when the telephone is not in use. Message window Shows the number of messages and other answering system information.

/VOL/ Adjust the base ringer volume or the speaker volume.

4. Place the handset in the telephone base or charger to charge. CHARGE light remains on when charging.

/FIND HANDSET Page all handsets and the headset. /REPEAT Repeat a message or press