Toro Power Max HD 926 OXE 26 inch 265cc Two Stage Snow Blower

Form No. 3369-555 Rev C

Power Max 926/928/1028 OXE Snowthrower Model No. 38661—Serial No. 312000001 and Up Model No. 38662—Serial No. 312000001 and Up Model No. 38663—Serial No. 312000001 and Up

Operator's Manual

Introduction This machine is intended to be used by residential homeowners or professional, hired operators. It is designed for removing snow from paved surfaces, such as driveways and sidewalks, and other surfaces for traffic on residential or commercial properties. It is not designed for removing materials other than snow, nor is a model with a pivoting scraper designed for clearing off gravel surfaces. Read this information carefully to learn how to operate and maintain your machine properly and to avoid injury and machine damage. You are responsible for operating the machine properly and safely. You may contact Toro directly at www.Toro.com for machine and accessory information, help finding a dealer, or to register your machine. Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service Dealer or Toro Customer Service and have the model and serial numbers of your machine ready. Figure 1 identifies the location of the model and serial numbers on the machine. Write the numbers in the space provided.

ST OP

G016493

1 Figure 1 1. Model and serial number location

Model No. Serial No.

This manual identifies potential hazards and has safety messages identified by the safety alert symbol (Figure 2), which signals a hazard that may cause serious injury or death if you do not follow the recommended precautions.

Figure 2 1. Safety alert symbol

This manual uses 2 words to highlight information. Important calls attention to special mechanical information and Note emphasizes general information worthy of special attention. This spark ignition system complies with Canadian ICES-002.

© 2012—The Toro® Company 8111 Lyndale Avenue South Bloomington, MN 55420

Register at www.Toro.com.

Original Instructions (EN) Printed in the USA All Rights Reserved

Safety Caution: Improper use may result in loss of fingers, hands, or feet.

Before Operating ? ?

Read and understand the contents of this manual before operating the snowthrower Become familiar with all controls and know how to stop the engine quickly .

.

There is a high-speed impeller close to the opening.

Operator 's Position

The low-speed auger has a moving pinch point close to the opening.

This machine meets or exceeds the B71.3 specifications of the American National Standards Institute in effect at the time of production.

• Keep the area of operation clear of all persons, particularly small children. • Exercise caution to avoid slipping or falling, especially when operating the machine in reverse.

Read and understand the contents of this manual before the engine is ever started.

Preparation

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.

• Thoroughly inspect the area where the machine is to be used and remove all doormats, sleds, boards, wires, and other foreign objects. • Disengage all clutches and shift into neutral before starting the engine. • Do not operate the machine without wearing adequate winter garments. Avoid loose fitting clothing that can get caught in moving parts. Wear footwear that will improve footing on slippery surfaces. • Handle fuel with care; it is highly flammable. – Use an approved fuel container. – Never add fuel to a running engine or hot engine. – Fill fuel tank outdoors with extreme care. Never fill fuel tank indoors. – Never fill containers inside a vehicle or on a truck or trailer bed with a plastic liner. Always place containers on the ground, away from your vehicle, before filling.

Improperly using or maintaining this machine could result in injury or death. To reduce this potential, comply with the following safety instructions.

Training • Read, understand and follow all instructions on the machine and in the manual(s) before operating this m