Sylvania SYL-WH930GB Wireless Headphones - 53a399ca-c282-444b-9bfd-ddacfb3c7fdc.pdf

OPERATION MANUAL

LOCATION OF CONTROLS

Listening to Your Songs on iPod

1.Alarm On/Off 2.Hour Set 3.Minute Set 4.Snooze Button 4.Time Set 6.Alarm Set 7.IPOD Jack 8.Power on/off 9.Speaker 10.LCD Display 11.FM/AM Tuning Knob 12.FM/AM Switching Button 13.AUX IN 14.AC 7V IN 15.Function Sitch (Ipod/Radio/Buzzer) 16.Volume Control Knob

1.To Listening to music,switch the button to iPod playback and “iPod” icon will be light on the LCD displayer. 2.Insert your iPod into the universal dock,Press the button on iPod to play the music. 9

1 2 3 4 5 6 7 8

9

Charging Your iPod Your iPod will always be charging until reaching the full charge mode.. Listening to Your Radio Station

AU X IN

11

12

AC 7V IN

13 14

15

16

10

1.To turn the radio on,swith the button to radio playback and “Radio” icon will be light on the LCD display. 2.To select AM or FM, switch the “AM/FM” button. 3.To tune in a desired station,rotate the “TUNING” knob. Listening to Other Audio Device lnsert one end of 3.5mm audio cable(not included) into the headphone or line-out jack on the audio device, then insert another end of audio cable into the AUX jack , located on the rear of unit.

IMPORTANT INFORMATION REQUIRED THE FCC This device complies with Part 15 of FCC Rules.Operation is subject to the following two conditions:(1) this device may not cause harmful interference;and(2) this device must accept any interference received,including interference that may cause undesirable operation. NOTE:This equipment has been testedand found to comply with the limits for a Class B digital device,pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and,if not installed and used in accordance with the insrtuctions, may cause harmful interference to radio elevation reception,which can be determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one or more of following measures. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. Setting The Clock To Set the time, Locate the “Time” button, press and hold the “Time” button down,and press “Hour” or “Min” button to adjust hour or minute. Time is displayed in the 12-Hour format. An icon to the left of the display indicated PM. Setting Alarm

Using the Alarm Function 1.To preview the alarm time, press the “alarm” button once in power-off status. 2.To activate or deactivate the alarm, press the “al-on/off” button,the “AL' icon will be light on or off on the LCD displayer. 3.To snooze, press “snooze” button, following the sounding of the alarm. The alarm will then shut off and will sound again in 5 minute, You will have the opportunity to repeat this cycle 12 times during one hour allotted alarm cycle. 4.To turn the alarm off, press the “power” or “al-on/off” button(only in Radio/Buzzer mode), lf all settings remain the same,the alarm will turn on the following day at the same time. Notes on Alarm Function 1.Snooze function is no effective in ipod mode. 2.When alarm is on in ipod mode,to turn off alarm,press “power” button,”al-on/off” button is no use. 3.Set your ipod to the repeat mode if you re selected wake to ipod, and your ipod has less then one hour of songs. 4.ln order to wake to ipod or radio ,the unit must be powered off . lf it is in the ipod/radio play mode,No alarm will sound. Set up the unit to work with the AC adapter Attach AC adaptor cable to AC 7V jack on the rear of unit, and plug the other end into a wall socket.

1.To set the Alarm,press and hold “Alarm ” button, and press “Hour ” or “Min” button to adjust hour or minute,Time is displayed in the 12-hour format. An icon to the left of the display indicated PM. 2.Switch”wake to …” button and select the option for sound