Stihl Ts 410 420 Cut Off Saw Decompression Grommet

BA_TS400_30_U_K5.pdf - Seite U1

STIH)

STIHL TS 400 Cutquik®

Instruction Manual Manual de instrucciones Warning! Read and follow all safety precautions in Instruction Manual - improper use can cause serious or fatal injury. Advertencia! Lea y siga todas las precauciones de seguridad dadas en el manual de instrucciones - el uso incorrecto puede causar lesiones graves o mortales.

English / USA

© ANDREAS STIHL AG & Co. KG, 2007 0458 338 8621. M3. D7. FST. Printed in Germany

Printed on chlorine-free paper. Printing inks contain vegetable oils; paper can be recycled.

BA_SE_062_003_01_08.fm

Contents

Guide to Using this Manual .............. 2 Safety Precautions and Working Techniques ......................... 3 Application Examples ..................... 18 STIHL composite resin cutting wheels ................................. 21 STIHL diamond cutting wheels ....... 21 Assembling the bearing and guard .......................... 25 Tensioning the V-belt ...................... 26 Abrasive wheels ............................. 27 Fitting / replacing an abrasive wheel ............................... 28 Fuel ................................................ 30 Fueling ............................................ 31 Starting / stopping the engine ......... 31 Cleaning the air filter ...................... 34 Motor Management ........................ 36 Adjusting Carburetor ...................... 36 Spark arresting screen in the muffler ................................... 37 Checking the Spark Plug ................ 37 Replacing the starter rope / rewind spring ........................ 38 Replacing the V-belt ....................... 41 STIHL cut-off machine cart ............. 42 Storing the machine ........................ 42 Maintenance chart .......................... 43 Parts and Control ............................ 44 Specifications ................................. 46 Special Accessories ....................... 47 Maintenance and Repairs ............... 47 STIHL Incorporated Federal Emission Control 2007Warranty Statement ................ 48 Trademarks .................................... 50

Allow only persons who understand this manual to operate your cut-off machine. To receive maximum performance and satisfaction from your STIHL cut-off machine, it is important that you read and understand the safety and maintenance precautions, starting on page 3, before using your cut-off machine. Contact your STIHL dealer or the STIHL distributor for your area if you do not understand some instruction in this manual.

!Warning! Because a cut-off machine is a highspeed cutting tool, some special safety precautions must be observed to reduce the risk of personal injury. Careless or improper use may cause serious or even fatal injury.

STIHl TS 400

1

English / USA

Guide to Using this Manual

Pictograms All the pictograms attached to the machine are shown and explained in this manual. The operating and handling instructions are supported by illustrations.

In addition to the operating instructions, this manual may contain paragraphs that require your special attention. Such paragraphs are marked with the symbols described below:

Symbols in text

Warning where there is a risk of an accident or personal injury or serious damage to property.

The individual steps or procedures described in the manual may be marked in different ways:

Caution where there is a risk of damaging the machine or its individual components.

:

Note or hint which is not essential for using the machine, but may improve the operator’s understanding of the situation and result in better use of the machine.

A bullet marks a step or procedure without direct reference to an illustration.

A description of a step or procedure that refers directly to an illustration may contain item numbers that appear in the illustration. Example: Loosen the screw (1) Lever (2) ...

2

Note or hint on correct procedure in order to avoid damage to the environment.

Equipment and features This instruction manual may refer to several models with different features. Components that are