Smartpool Nitro Wall Climber In-Ground Robotic Pool Cleaner NC51 - 2012-NC71-Manual%20U.S.pdf

SMARTPOOL SCRUBBER60 (NC71) ROBOTIC POOL CLEANER OPERATION MANUAL

1.1.A

IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS ! DANGER:

Risk of electrical shock or electrocution – The electrical supply to this product must be installed in accordance with the National Electrical Code and all applicable local codes and ordinances. Improper installation will create an electrical hazard which could result in death or serious injury to pool users or others due to electrical shock, and may also cause damage to property.

! WARNING: DO NOT USE EXTENSION CORDS - DEATH OR INJURY CAN RESULT. ! WARNING: To reduce the risk of injury, do not permit children to use this product unless they are closely supervised at all times ! WARNING: If ambient air temperature exceeds 115˚ F., protect the power supply from direct sunlight. Do not cover the power supply. ! WARNING: The sole purpose of this product is for use as a robotic pool cleaner as described in this manual; any modification or other use will void the warranty. ! WARNING: Do not allow children to use, touch, or play near or around the units’ power supply. ! WARNING: A Ground Fault Current Interrupter (GFCI-USA) and Earth Leak Interrupter (ELI-EU) must be installed to protect your electrical outlet and to prevent any possible electric shock. Failure to do so could create an electrical hazard which could result in death or serious injury to pool users or others due to electrical shock and may also cause damage to property.

! WARNING: Do not connect unit to AC power until installation has been completed. ! WARNING: Do not use if unit is damaged in any way. ! WARNING: Unit must be completely submerged in water or warranty is void. ! WARNING: Make sure the robotic pool cleaner is unplugged from its power supply before opening the unit or performing any other maintenance. ! WARNING: To avoid damage to the power supply and cord, never carry the power supply by the cord or pull on the cord to disconnect from an outlet. Instead, disconnect by pulling the plug, itself, from the outlet. Do not pull cord around sharp corners or edges.

! WARNING: Do not play with the cleaner or cable or apply to body. It can trap or tear hair or body parts. The cable can trip or entangle swimmers which could result in drowning. ! WARNING: Do not operate with a damaged cord or power supply. ! WARNING: Before installing the cleaner, understand the cleaners coverage. The cleaner was not designed to automatically clean steps or to work under solar covers. It was also not designed to do initial clean up for a new pool installation.

! WARNING: Your cleaner should not be used while people are swimming in the pool. ! WARNING: The power supply must be at least 12 feet / 4 meters from the pool’s edge at all times! ! CAUTION: It is recommended that you clean your filter bag and check the impeller to make sure it is free and clear of debris after every use. ! CAUTION: Disconnect the power supply from the outlet when not in use. ! CAUTION: DO NOT switch the pool cleaner to “ON” if it is not immersed in the water. Operation the cleaner out of the water may cause severe damage and will result in loss of warranty. Always remember to turn the power supply “OFF” and unplug it from the power outlet before removing the cleaner from the pool.

! CAUTION: If your robotic pool cleaner is not working as it should or has been dropped or damaged in any way, contact SmartPool, Inc. Customer Service before using at 1-732730-9880 or visit our website at www.smartpool.com.

SAVE THESE INSTRUCTIONS www.smartpool.com 1.1.A

2

Congratulations on your purchase of the most technologically advanced automatic pool vacuum available today. The Scrubber60 is easy to use and will make maintaining your pool affordable and effortless. Following these simple directions will insure that the Scrubber60 will quickly and efficiently clean your pool today and for many years to come.

INSTALLATION • • • • •

Check to make sure the power supply is in the off position. Plug the power supply into a GFL (ground Fault Interrupted) or ELI (Earth