Simplicity 2924 Sewing Pattern Baby Accessories & Diaper Bags UNCUT - sim2924.pdf

English

Web Site

U.S. & Canada Toll-Free

e

http://www.simplicity.com

1 - 8 8 8 -5 8 8 -2 7 0 0

1/4

pattern printed side down

Cutting Layouts

★ ✻

pattern printed side up

See SPECIAL CUTTING NOTES

E-mail

[email protected]

Thank you for purchasing this Simplicity pattern. We have made every effort to provide you with a high quality product

POSITION OF PATTERN PIECES MAY VARY SLIGHTLY ACCORDING TO YOUR PATTERN SIZE

C CHANGING PAD

SELVAGE

F BIB

USE PIECE 10

USE PIECES 13 14

FOR TERRYCLOTH AND CLEAR VINYL FOLLOW SAME LAYOUT

FOR CLEAR VINYL FOLLOW SAME LAYOUT

General Directions For Cutting PRE-SHRINK and iron all fabric. FOR DOUBLE THICKNESS-Fold fabric with RIGHT sides together. Pin pattern to WRONG side of fabric.

SELVAGE

SINGLE THICKNESS

2924

SINGLE THICKNESS

®

10

FOR SINGLE THICKNESS-Pin pattern to RIGHT side of fabric.

shows a piece extending past fold, cut out all pieces except piece ★ Ifthatlayout extends. Open out fabric to single thickness. Cut extending piece on

13

SELVAGE

SELVAGE

RIGHT side of fabric in position shown.

fabric layer around so arrows on both layers go in the same direction. Place RIGHT sides together.

SELVAGE

D BURP CLOTH USE PIECE 11 FOR TERRYCLOTH FOLLOW SAME LAYOUT

A B

A,B DIAPER BAG USE PIECES 1 2 3 4 5 6 7

SINGLE THICKNESS

small arrows along both selvages indicating direction of nap or design. ✻ Mark Fold fabric crosswise with RIGHT sides together, and cut along fold. Turn one

G DIAPER WIPES BAG SELVAGE

USE PIECES 15 16

SEL. 16

SELVAGE

D

14

11 15 SELVAGE

E F

G

FOLD

SINGLE THICKNESS

C

H A&B

6 SELVAGES SELVAGES 3 7

5

2

7

E TUMMY PILLOW H PACIFIER CLIP

USE PIECE 12 1

4

4

FOR BATTING FOLLOW SAME LAYOUT

SEE SEWING DIRECTION FOR CUTTING 12

SELVAGE

FOLD

FOLD

16 pieces given

3 2

1

15 7

Sewing Directions

5

4

FABRIC KEY

LINING USE PIECES 1 2 3 4 5 6 8 9

RIGHT SIDE

WRONG SIDE

INTERFACING

LINING

Read General Directions on page 1 before you begin.

9 SELVAGE

6

14

16

SINGLE THICKNESS

11

8

10

12 13

4

4

INNER SELVAGES

5

6

OUTER

3 2

8

9

1-FRONT AND BACK -A,B

NOTE: With RIGHT sides together, stitch 1/2" (1.3cm) seams and press all seams open, unless otherwise indicated. Sewing procedures ITALICIZED in Sewing Directions are defined below: CLIP CURVES to make seams lie flat. Inner Curve - Make little clips, or snips, in the seam allowance just to, but not through, the stitching. Outer Curve - Cut little wedge-shaped notches from seam allowance.

CLIP CURVES

1 FOLD

SELVAGE

2-BACK POCKET -A,B 3-SIDE -A,B

DOUBLE FOLD BIAS TAPE -The tape comes prefolded, with one side slightly wider than the other. The wider side is to be used on the WRONG side of the garment so that when the tape is stitched in place from the RIGHT side, both edges are sure to be caught in the stitching.

4-SIDE POCKET -A,B 5-BOTTOM -A,B 6-FLAP -A,B

INTERFACING

7-STRAP -A,B

USE PIECES 1 2 3 5 6 7

8-INSIDE POCKET -A,B

DOUBLE FOLD BIAS TAPE

20" TO 25" (51CM TO 64CM) FUSIBLE

11-BURP CLOTH -D 12-TUMMY PILLOW -E 13-BIB -F 14-BIB POCKET -F 15-BAG -G 16-FLAP -G

© Copyright 2008—Simplicity Pattern Co., Inc. / Printed in U.S.A. / Simplicity is a registered trademark of Simplicity Pattern Co., Inc.

SELVAGE

SELVAGES

★

INWARD CURVE

3 6

5

2

SELVAGE

CROSSWISE FOLD

10-CHANGING PAD -C

SINGLE THICKNESS

9-BASE -A,B

1 3 7 SELVAGES

OUTWARD CURVE

Curves: If tape is applied to a curved surface, first, preshape it with a steam iron. For an inward curve, stretch the double edges and press; for an outward curve, stretch the fold edge and press.

English

2924

DIAPER BAG A, B

2/4 1

1. Apply INTERFACING to back pocket. With RIGHT sides together, stitch lining to pocket along unnotched edge. Trim seam.

Corners: Encase one edge all the way to raw edge of fabric. Raise presser foot and cut the thread. Turn tape around corner and pin in place. Fold tape diagonally on both sides of corner; lower needle into diagonal fold and stitch the remaining side. 2 2. Turn pocket RIGHT side out; press. Baste raw edges together. Top-stitch 1/4” (6mm) from finished