RC ARF Long EZ .46 Pusher Nitro Gas Radio Remote Control Plane

ARF Long EZ .46 Voyager Nitro Gas RC Plane RC Remote Control Radio

90A149W-Gas-LongEZ-White

Please drill 1 mm pilot holes for the modified horn. When assembling the servo, please lengthen the leads and go through the hole like the diagram and use the PM2X11mm screw assembled the rtl horn, then use the PWN1X11mm screw to install the plywood.

Insert the elevator pushrod into the hole at the front of the fuselage, then put the steelplant into according to the diagram.

After assemble the pushrod, insert the elevator into the hold, then make some mark and peel off the film according to the marks. Use ruler to measure the length, make sure the length of the two sides is equivalent.

After assemble the pushrod, insert the elevator into the hole, then make some mark and peel off the film according to the marks. Use ruler to measure the length, make sure the length of the two sides is equivalent.

Safile the shake memfor pushrod, then assemble the landing gear according to the diagram. In the assemble, use 1 mm reller.

First put the inside canopy on the fuselage, assemble the PMA2X12mm screw. Then settle the outside canopy, and assemble the PMA2X12mm screw.