Poulan Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin

ENGLISH

R

Please do not return unit to retailer. Por favor, no devuelva el aparato al lugar de compra. Veuillez ne pas retourner l’outil au détaillant.

1--800--554--6723 www.poulan.com

Instruction Manual Manual de Instrucciones Manuel d’Instructions

For Occasional Use Only

ESPAÑOL

P3314 / P3314WS / P3314WSA P3416 / P3516PR / P4018WM P4018WT / P3818AV P4018AV / P4018AV BH

WARNING:

Read and follow all Safety Rules and Operating Instructions before using this product. Failure to do so can result in serious injury.

ADVERTENCIA:

Lea el manual de instrucciones y siga todas las advertencias e enstrucciones de seguridad. El no hacerlo puede resultar en lesiones graves.

AVERTISSEMENT:

Lire le manuel d’instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Poulan 850 Matheson Blvd. West Mississauga, Ontario L5V 0B4

545186804 Rev. 2

3/15/09 BRW

FRANÇAIS

Poulan 1030 Stevens Creek Road Augusta, GA 30907

IDENTIFICATION OF SYMBOLS WARNING! This chain saw can be dangerous! Careless or improper use can cause serious or even fatal injury.

Read and understand the instruction manual before using the chain saw.

Always wear appropriate ear protection, eye protection and head protection.

Always use two hands when operating the chain saw.

WARNING! Contacting the guide bar tip with any object should be avoided; tip contact may cause the guide bar to move suddenly upward and backward, which may cause serious injury. XX_

Measured maximum kickback value without chain brake for the bar and chain combination on the label.

Starting Reminder Move ON/STOP switch to the ON position.

Pull the starter rope sharply 5 times with your right hand.

Slowly press primer bulb 6 times.

Push the choke/fast idle lever in to the HALF CHOKE position.

Pull choke/fast idle lever out to the full extent (to the FULL CHOKE position).

Pull the starter rope sharply with your right hand until the engine starts.

SAFETY RULES PLAN AHEAD

WARNING:

Always disconnect spark plug wire and place wire where it cannot contact spark plug to prevent accidental starting when setting up, transporting, adjusting or making repairs except carburetor adjustments. Because a chain saw is a high-speed woodcutting tool, special safety precautions must be observed to reduce the risk of accidents. Careless or improper use of this tool can cause serious injury.

2

S Read this manual carefully until you completely understand and can follow all safety rules, precautions, and operating instructions before attempting to use the unit. S Restrict the use of your saw to adult users who understand and can follow safety rules, precautions, and operating instructions found in this manual. S Wear protective gear. Always use steeltoed safety footwear with non-slip soles; snug-fitting clothing; safety chaps; heavy-

duty, non-slip gloves; eye protection such as non-fogging, vented goggles or face screen; an approved safety hard hat; and sound barriers (ear plugs or mufflers) to protect your hearing. Regular users should have hearing checked regularly as chain saw noise can damage hearing. Secure hair above shoulder length. Hearing Protection Snug Fitting Clothing

Safety Shoes

S With the engine stopped, hand carry the chain saw with the muffler away from your body, and the guide bar and chain to the rear, preferably covered with a scabbard.

MAINTAIN YOUR SAW IN GOOD WORKING ORDER

S Have all chain saw service performed by a qualified service dealer with the exception of the items listed in the maintenance section of this manual. For example, if improper tools are used to remove or hold the flywheel when servicing the clutch, structural damage to the flywheel can occur and cause the flywheel to burst. S Make certain the saw chain stops moving when the throttle trigger is released. For correction, refer to CARBURETOR ADJUSTMENT. S Never modify your saw in any way. S Keep the handles dry, clean, and free of oil or fuel mixture. S Keep fuel and oil caps, screws, and fasteners sec