Pentair Minimax NT Heater

MasterTemp® and Max-E-Therm® Pool Heaters Combustion Chamber (New Tub Design) Replacement Parts

ADDENDUM (NON-ASME MODELS ONLY)

IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONS WARNING FOR YOUR SAFETY - READ BEFORE OPERATING This product must be installed and serviced by a professional service technician, qualified in pool heater installation. Some jurisdictions require that installers be licensed. Check with your local building authority about contractor licensing requirements. Improper installation and/or operation could create carbon monoxide gas and flue gases which could cause serious injury or death. Improper installation and/ or operation will void the warranty. For additional free copies of these instructions; call (800) 831-7133.

Combustion Chamber Clamp Assy.

R PUMP

BOOSTE SPEED HIGH

AUX 1

FILTER PUMP

Combustion Chamber Lid Assy. [P/N 474094] Combustion Chamber O-Ring

AUX 2

SPEED LOW

MasterTemp®

Max-E-Therm®

New Tub Design KITS P/N

DESCRIPTION

474094 474095

Combustion Chamber Lid Assembly Kit ➊ Combustion Chamber (Tub) Kit ➊

KITS include: Clamp Assy., O-Ring, and Silicone Tube

Combustion Chamber (Tub) [P/N 474095]

➊ These Combustion Chamber Kits are used for the Max-E-Therm® heaters manufactured after 1/12/09 and the MasterTemp® heaters manufactured after 1/29/09. See reverse side for Heat Exchanger Kits.

Pentair Water Pool and Spa, Inc. 1620 Hawkins Ave., Sanford, NC 27330 • (800) 831-7133 • (919) 566-8000 10951 W. Los Angeles Ave., Moorpark, CA 93021 • (800) 831-7133 • (805) 553-5000 Visit us on the Internet at: www.pentairpool.com or www.staritepool.com Rev. A 4-9-09

1

P/N 474074

HEAT EXCHANGER KITS P/N

DESCRIPTION

474058 474059 474060 474061 474062 474063 474064 474065

Tube Sheet Coil Assembly Kit Tube Sheet Coil Assembly Kit Tube Sheet Coil Assembly Kit Tube Sheet Coil Assembly Kit Tube Sheet Coil Assembly Kit Tube Sheet Coil Assembly Kit Tube Sheet Coil Assembly Kit Tube Sheet Coil Assembly Kit

MODELS (New Tub Design) (New Tub Design) (New Tub Design) (New Tub Design) (New Tub Design) (New Tub Design) (New Tub Design) (New Tub Design)

175 NA & LP, 200 NA & LP 250 NA & LP 300 NA & LP, 333 NA & LP 400 NA & LP 200 (HD) NA & LP 250 (HD) NA & LP 333 (HD) 400 (HD) NA & LP

KITS include: Clamp Assy., O-Ring, Insulation Kit (Top & Bottom), Silicone Tube

Save These Instructions Together With Your Existing Operation & Installation Manual For Future Reference.

© 2009 Pentair Water Pool and Spa, Inc. All rights reserved. This document is subject to change without notice.

1620 Hawkins Ave., Sanford, NC 27330 • (800) 831-7133 or (919) 566-8000 10951 West Los Angeles Ave., Moorpark, CA 93021 • (800) 831-7133 or (805) 553-5000 Trademarks and Disclaimers: Pentair Pool Products® , Because reliability matters most ® , Sta-Rite®, MasterTemp®, Max-E-Therm® are trademarks and/or registered trademarks of Pentair Water Pool and Spa, Inc. and/or its affiliated companies in the United States and/or other counties. Unless noted, names and brands of others that may be used in this document are not used to indicate an affiliation or endorsement between the proprietors of these names and brands and Pentair Water Pool and Spa, Inc. Those names and brands may be the trademarks or registered trademarks of those parties or others.

P/N 474074

2

Rev. A 4-9-09