Koolatron CVF18 Coca-Cola Retro 10-Can-Capacity Vending - 0H6448.pdf

INSTALLATION GUIDE For Pre-wired Automatic Switch/Load Center Models: 10, 12, 14 and 16 Circuit. Installed with 8, 11, 13, 14, 16, 17kW Generators. This Automatic Transfer Switch with built-in Load Center includes an Express Install Kit. • Saves on installation time and cost, in many cases up to 50% compared to traditional transfer switch installations. • Automatically supplies electricity to essential critical circuits. • Can be installed prior to, or along with generator installation.

Reference all appropriate documentation. This manual should remain with the unit.

C LISTED

US

Table of Contents INSTALLATION GUIDE .......................................................................................................................1 INSTALLATION DRAWINGS/WIRING DIAGRAMS ..........................................................................10

WARNING!

California Proposition 65 Engine exhaust and some of its constituents are known to the state of California to cause cancer, birth defects, and other reproductive harm.

WARNING!

California Proposition 65 This product contains or emits chemicals known to the state of California to cause cancer, birth defects, and other reproductive harm.

Residential Transfer Switch Installation Guide PLEASE NOTE: This installation guide should be used in conjunction with the “Installation and Owner’s Manual” that is furnished with the Air-cooled Standby Generator. Please review both manuals prior to installation of the generator and transfer switch. This Automatic Transfer Switch/Load Center is not intended for use with the Liquid-cooled Generator product line. This unit is not compatible with other generator manufacturer’s products.

INTRODUCTION Thank you for purchasing this pre-wired Automatic Transfer Switch/Load Center with Express Install Kit. The Express Install Kit includes: • 30 foot, five foot, and two foot pre-wired conduits for making all required wiring runs. • An outdoor junction box for making connections between outdoor and indoor pre-wired conduits. • UL listed wire nuts for reconnecting emergency circuits within the main distribution panel. The Automatic Transfer Switch/Load Center with Express Install Kit can be installed along with a 8, 11, 13, 14, 16, 17 kW Air-cooled Standby Generator, or can be used to pre-wire a home or small business in advance of generator installation. In either case, the Express Install Kit saves installation time and cost, since the majority of labor involved in installing a standby power system is in wiring the generator, automatic transfer switch and emergency circuit subpanel. Four commonly used safety symbols accompany the DANGER, WARNING and CAUTION blocks. The type of information each indicates follows:

Indicates a hazardous situation or action which, if not avoided, will result in death or serious injury.

Indicates a hazardous situation or action which, if not avoided, could result in death or serious injury.

Four commonly used safety symbols accompany the DANGER, WARNING and CAUTION blocks. The type of information each indicates is as follows:

symbol points out important safety information that, if not followed, could endanger This personal safety and/or property of others.

ard. This symbol points out potential fire hazard. 

This symbol points out potential explosion haz-

shock hazard.

This symbol points out potential electrical SAVE THESE INSTRUCTIONS – The manu-

suggests that these rules for safe  facturer operation be copied and posted near the unit’s installation site. Safety should be stressed to all operators and potential operators of this equipment. The manufacturer cannot anticipate every possible circumstance that might involve a hazard. The warnings in this manual, and on tags and decals affixed to the unit are therefore, not all-inclusive. If using a procedure, work method or operating technique the manufacturer does not specifically recommend, ensure that it is safe for all personnel. Also make sure the procedure, work method or operating technique chosen does not render the equipment unsafe.

ELEC