Jacuzzi MAGNUM FORCE POOL PUMP 2 HP 115230V 94027120 - jacuzzi_magnum.pdf

Jacuzzi MAGNUM FORCE POOL PUMP 2 HP 115230V 94027120 Owners Manuals, User Guides, Instructional Help Documents & Operating Information - jacuzzi_magnum.pdf

Report DMCA / Copyright

DOWNLOAD PDF

  • 560KB
  • 8 Pages
  • 612 x 792 pts (letter)
  • 82 Downloads
  • 340 Views

 

Citation

Jacuzzi

Magnum, RC, LR, Cygnet

®

Owner’s Manual

E-1451

WARNING – (For cord & plug connected units). To reduce the risk of electrical shock do not use an extension cord to connect unit to electrical supply; provide a properly located outlet. 7. CAUTION – (For pumps with a 25 ft. (7.62m cord). This pump is for use with storable pools only. Do Inspection not use with permanently installed pools. A storable Examine the equipment when received. Notify your pool is constructed so that it may be readily dealer or carrier of any damage or missing parts. Verify disassembled for storage and reassembled to its that equipment is of size and model specified. original integrity. A permanently installed pool is constructed in or on the ground or in a building such that it cannot be readily disassembled for storage. Important Safety Instructions 8. CAUTION – (For pumps with/without 3ft. (.91m When installing and using this electrical equipment, cord). This pump is for use with permanently basic safety precations should always be followed, installed pools and may also be used with hot tubs including the following: and spas if so marked. Do not use with storable 1. READ AND FOLLOW ALL INSTRUCTIONS. pools. A permanently installed pool is constructed 2. WARNING – To reduce risk of injury, do not permit in or on the ground or in a building such that it children to use this product unless they are closely cannot be readily disassembled for storage. A supervised at all times. storable pool is constructed so that it may be readily 3. WARNING – (For cord & plug connected units). Risk disassembled for storage and reassembled to its of Electrical Shock. Connect only to a grounding type original integrity. receptacle protected by a ground-fault circuit9. WARNING – (For hot tub and spa pumps). Do not interrupter (GFCI). Contact a qualified electrician if install within an outer enclosure or beneath the skirt you cannot verify that the receptacle is protected by a of the hot tub or spa, unless so marked. GFCI. 10. SAVE THESE INSTRUCTIONS! 4. WARNING – (For cord & plug connected units). Do Installation Location not bury cord. Locate cord to minimize abuse from Locate pump as close to pool/spa as possible, lawn mowers, hedge trimmers and other equipment. preferably in a dry, well ventilated area away from direct 5. WARNING – (For cord & plug connected units). To sunlight. It should be on a hard, level surface. Give reduce the risk of electric shock, replace damaged consideration to: cord immediately. Before installation, be sure to read all instructions and warnings carefully. Refer to product dataplate(s) for additional operating instruction and specifications.

should be on a hard, level surface. Give consideration to:

6.

the pump discharge. The valves are essential for pump

1. Drainage – away from pump. 2. Ventilation of pump motor. 3. Access for future servicing and winterizing. 4. Protection from the elements. Pumps without strainer bodies are designed for flooded suction (all suction fittings and suction piping below water level) and will not self-prime. Consequently, the pump must be installed at an elevation that is below water level when pool or spa is filled; however, if suction line valves are installed, the pump may be closed for priming. Keep vertical distance to a minimum if you choose to mount pump above water level. Pumps with strainer bodies are self-priming but should be mounted as close to the water level as possible or below for ease in priming. General Plumbing FOR SOLVENT WELD CONNECTION Rigid or flexible PVC pipe can be used. Pipe ends should be clean and free of any flash cause by the cutting operation. Be sure that the proper adhesive is used on the type of pipe specified. Recommended Adhesives – These are examples only and are not intended to restrict brands. PVC – PVC Joint PVC – PVC Joint Uni-Weld Pool-Tite 2000 Uni-Weld Pool-Tite 2000 Suregard Flex 20 Suregard Weld-All No. 5 IPS Weld-On 705 IPS Weld-On 794 Note: A primer will assure that adhesive joints are superior. Suregard P-3000 has a purple tracer to qualify i