GE DBVH512EFWW Dryer

GE DBVH512EFWW Dryer Owners Manuals, User Guides, Instructional Help Documents & Operating Information - GE%20Dryer%20-%20DBVH512EFoWW%20Install%20Instructions.pdf

Report DMCA / Copyright

DOWNLOAD PDF

  • 241KB
  • 8 Pages
  • 612 x 792 pts (letter)
  • 48 Downloads
  • 262 Views

 

Citation

Installation Instructions

Stack Bracket Kit

BEFORE YOU BEGIN Read these instructions completely and carefully. •

IMPORTANT – Save these instructions for local electrical inspector’s use.



IMPORTANT – Observe all

WE25X10018 MINIMUM CLEARANCE OTHER THAN ALCOVE OR CLOSET INSTALLATION Minimum clearance to combustible surfaces and for air opening are: 0″ both sides and 1″ rear. Consideration must be given to provide adequate clearance for installation and service.

governing codes and ordinances. • Note to Installer – Be sure to leave these instructions with the Consumer.

ALCOVE OR CLOSET INSTALLATION

• Note to Consumer – Keep these instructions for future reference.

• If your dryer is approved for installation in an alcove or closet, it will be stated on a label on the dryer back.

• Installation must be performed by a qualified installer. • Proper installation is the responsibility of the installer.

FOR YOUR SAFETY:

WARNING • Electric Shock Hazard. Disconnect power before installing. Failure to do so could result in serious injury or death. • Potential Personal Injury. More than two people are recommended to lift the dryer into position because of its weight and size. Failure to do so could result in personal injury or death. • Avoid Tipping and Rupture of Utility Services. Dryer must be securely attached to the washer. DO NOT place the washer on top of the dryer. Failure to do so could result in personal injury/death or property damage. • Mobile Home or Manufactured Home Installation – Stacking of a gas dryer is not permitted in a mobile home or manufactured home.

175D1807P508 49-90240 05-05 JR

• The dryer MUST be vented to the outdoors. Refer to dryer Installation Instructions for details. • Minimum clearance between dryer cabinet and adjacent walls or other surfaces is: 0″ either side 3″ front and rear • Minimum vertical space from floor to overhead cabinets, ceiling, etc. is 43″ without pedestal, 55″ with pedestal and 84″ stacked. • Closet doors must be louvered or otherwise ventilated and must contain a minimum of 60 square inches of open area equally distributed. If the closet contains both a washer and a dryer, doors must contain a minimum of 120 square inches of open area equally distributed.

Installation Instructions KIT CONTENTS

1 REMOVE THE DRYER LEVELING LEGS

Right Hand Bracket

A

Carefully lay the dryer on its side. Use the packing material so you don’t scratch the finish on the dryer.

B

Use an open-end wrench or pliers to remove the dryer leveling legs.

Left Hand Bracket

4 Rubber Pads

4 #12 x 1” Screws

4 #8 x 1/2” Screws

TOOLS YOU WILL NEED Phillips Screwdriver Back out and remove all 4 leveling legs Open Ended Wrench

Pliers

2 INSTALL RUBBER PADS TO DRYER BASE Locate the 4 rubber pads in the parts package. Remove the adhesive backing and firmly place over on the bracket where you removed the levelling legs.

Gloves

Level

INSTALLATION PREPARATION Remove the packaging. Flatten the product carton to use as a pad to lay the dryer down on its side. Continue using the carton to protect the finished floor in front of the installation location.

2

Installation Instructions 3 INSTALL BRACKET TO DRYER A

B

5 INSTALL DRYER AND BRACKET ON WASHER

Align the holes in the left bracket with the holes in the bottom left corner of the dryer. Use a Phillips screwdriver to install the 2 #12 x 1” tapping screws. Repeat the above step with the right bracket on the bottom right corner of the dryer.

A

Lift the dryer on top of the washer. Be careful not to scratch the top of the washer with the brackets. Protect the washer control panel with cardboard or other protection. Be sure to lift the dryer high enough to clear the washer control panel.

WARNING Potential Personal Injury. More than two people are recommended to lift the dryer into position because of its weight and size. Failure to do so could result in personal injury or death. B

C

Set the dryer upright.

NOTE: Make sure to set the dryer on a piece of packing material so the brackets that are attached to the bottom of the dryer do not damag