Fahrenheat LFP6152 Halogen Baseboard Heater - qmark_lfpmanual fahrenheat base heater.pdf

The Choice of Professionals

LFP Series Portable Electric/Hydronic Baseboard Heaters

FILE #E37116

Installation & Maintenance Instructions Dear Owner, Congratulations! Thank you for purchasing this new heater manufactured by a division of Marley Engineered Products. You have made a wise investment selecting the highest quality product in the heating industry. Please carefully read and follow the installation and maintenance directions shown in this manual. You should enjoy years of efficient heating comfort with this product from Marley Engineered Products... the industry’s leader in design, manufacturing, quality and service. ... The Employees of Marley Engineered Products !

WARNING

Read Carefully - This instruction sheet contains vital information for the proper installation, use and efficient operation of the heater. Carefully read the manual before installation, operation, or cleaning of the heater. Failure to adhere to the instructions could result in fire, electric shock, death, serious personal injury or property damage. Save these instructions and review frequently for continuing safe operation and instructing future users. WARNING: HAZARD OF FIRE OR ELECTRICAL SHOCK. 1. This heater is a major electrical appliance and requires adequate electrical connections for safe use. The outlet to which the heater is connected must be a 120 volt (AC) circuit protected by a 15 or 20 amp fuse or circuit breaker in accordance with the National and Local Electrical Codes. No other major electrical appliance should be operated in the same circuit as the heater. 2. Plug heater power cord directly into the electrical outlet. DO NOT use an extension cord with this heater. When the heater is not to be used for an extended time, turn the on/off switch off and unplug power cord from outlet. Move heater to safe storage place to prevent damage.

3. Heater surfaces may reach high temperatures during use. Keep all electrical cords, drapes, bedding materials, and other furnishings away from heater. NEVER place anything onto the heater. 4. DO NOT operate the heater without both support legs installed. DO NOT allow heater to operate in any position except as shown in this manual. 5. DO NOT store or use gasoline or other flammable vapors or liquids in the vicinity of this heater. 6. DO NOT use this heater near water (as in a wet basement or a swimming pool) or in a very humid environment. 7. This heater is to be used on the floor only. DO NOT use on shelf, table, or any location except the floor. 8. Keep this heater clean. DO NOT allow dirt or dust to accumulate around element fins or the outlet air grille area. See Cleaning Instructions section of this manual. 9. If this heater or its power cord become damaged or malfunction in any way, unplug heater, discontinue use, and have unit repaired by a reputable repair service.

SAVE THESE INSTRUCTIONS 1

HEATER ASSEMBLY 1. After removing the heater from its carton, carefully inspect it for possible shipping damage. Return damaged units to point of purchase. 2. Remove one plastic support leg and thermostat knob from packaging in bottom of heater. The right hand support leg is pre-assembled to the power cord and requires only to be slid into place as shown in Figure 1.

HEATER OPERATION (Model LFP6152) 1. Your heater is provided with an on/off switch, power on pilot light (in switch), low and high output pilot lights, and a “smartstat” temperature control thermostat. 2. To operate your heater simply: a. Plug heater power supply cord into 120 volt outlet (see warnings 1, 2, 4, and 7).

3. Fit left hand support leg onto heater and snap into position as shown in Figure 1.

b. Push on/off switch to on position. NOTE: The power on pilot light in switch will be on.

4. Position thermostat knob onto thermostat shaft as shown in Figure 1.

c. Rotate smartstat thermostat knob in a clockwise direction until it stops.

NOTE: The knob will only fit onto shaft in one way.

THERMOSTAT KNOB

Figure 1

SUPPORT LEGS

HEATER OPERATION (Models LFP675 and LFP610) 1. Your heater is provided with an on/off switch, pow