EIDE... 160 GB Hard Drive

Seagate Barracuda 7200.10 ST3160815A - 160GB - 7200rpm - Ultra ATA/100 - IDE/EIDE... 160 GB Hard Drive Owners Manuals, User Guides, Instructional Help Documents & Operating Information - C:\Documents and Settings\Owner\My Documents\Seagate72.pdf

Report DMCA / Copyright

DOWNLOAD PDF

  • 90KB
  • 1 Pages
  • 612 x 792 pts (letter)
  • 32 Downloads
  • 359 Views

 

Citation

Basic jumper settings for Seagate Barracuda ATA Hard Drives Thank you for purchasing your new ATA hard drive from Other World Computing! Please review these jumper settings prior to installing your new hard drive into your computer. You may want to review more detailed information about the installation process, or the location and configuration of your existing internal ATA drive before proceeding. Your manual that came with your computer can be of assistance in both of these determinations. A few notes about installing an ATA hard drive into your existing system: Your existing drive is normally configured one of two ways, Master (single drive), or Cable Select. You will want to determine this before installing your new drive, the easiest way is to remove the existing drive from your system and visually inspect it’s hard drive jumpers. Most hard drives have a schematic either silk screened onto the case of the drive, or the schematic is on a label near the jumper pins. If you have difficulty locating this information, visit the hard drive manufacturer’s website. If your existing hard drive is configured as “Master”, then set your new hard drive to “Slave”. If your existing drive is set for “Cable Select”, then set your new drive to “Cable Select” also. You can change the existing jumper settings on the original drive to suit your needs, but we recommend following these instructions first to verify proper operation of the new hard drive. Installing jumpers on the new drive is a simple process, follow the schematic to configure your drive.

Please note the configuration of the internal ATA cable already installed in your existing system. If your internal cable is configured differently than pictured here, you may want to replace it before installing a new hard drive to achieve maximum performance. For further assistance, visit our tech center at http://eshop.macsales.com/Tech/index.cfm