Dryer

Tecnik TKL9290 Front Load Washer / Dryer Owners Manuals, User Guides, Instructional Help Documents & Operating Information - TKL 9290 Instruction Manual .pdf

Report DMCA / Copyright

DOWNLOAD PDF

  • 341KB
  • 16 Pages
  • 425 x 595 pts
  • 48 Downloads
  • 318 Views

 

Citation

TM

TECNIK

TKL 9290 WASHER DRYER

Instructions manual

! e r a c e r o m g n i k a T

INSTRUCTIONS FOR THE INSTALLATION ATTENTION: The washing machine must be trucked from the left hand side only (see packing label). Remove the thermoretractable film. 1 – Open the porthole door and take out the plastic bag con taining the accessories. Lay down the machine on the left side leaning it on the corner, remove the packing base, and take out the two tub inside supports made by foamed part. 2 – Install the nuts on the levelling feet (you will find them in the plastic bag); screw the 4 feet on the machine, screw ng the 2 reaer feet and the front right one completely by means of the provided special key. Put the machine back to the standing position. 3 – Unscrew the 3 screws of the back packing rods by means of the key (without removing them completely). 4 – Remove the rods (3) and close the holes by means of the clos ing plugs that you will find in the plastic accessories bag.In case of future transportation of the washing machine it is advisable to keep the rods.

RECOMMANDATION FOR THE USER How to use your washing machine economically and ecologically. Optimum load - Always try to use the washing machine at full load, as this will use less water, powder and energy thant two smaller loads. You want to use the pre-wash? - Only the pre-wash for very dirty linen. If you don’t use the pre-wash, you save from 5% to 15% in energy, washing powder, and time. Is a high temperature wash required? - To avoid high temperature washing, treat particularly dirty items with a stain remover of leava the most stains to soak beforehand. You will save energy in this way.

THIS APPLIANCE COMPLIES WITH EUROPEAN DIRECTIVES – EMC 89/336/EEC – LOW VOLTAGE 73/23/EEC – EEC-LABELLING 93/68/EEC

CLEANING AND MAINTENANCE This washing machine does not require any particular maintenance. At the end of each wash it is recommended to leave the door open so that air will circulate and dry the interior of the machine. The external part of the machine should never be cleaned with abrasive detergents since this would ruin the enamel coating as well as the synthetic parts. Removing and cleaning filter Place a rag under the washing machine to absorb any residual water. The filter is located under the base. Turn the filter handle counterclockwise and pull out the filter. Clean it under running water. Reinsert the filter and turn the handle clockwise until it is completely locked. WARNING: Water may leak from the filter if it is not properly tightened. Remember to clean the filter frequently to avoid excessive clogging. TEL. 08705 678910 BEFORE CALLING THE TECHNICAL SERVICE CENTER: – Check if plug is inserted – Check that power is available – Check that the door is properly closed – Check that the water tap is open – Check that the water supply hose and water drain hose – Are not blocked – Check that the pump filter is clean NOTE: If you have to call the service center, specify the model of your washing machine and if necessary the serial number which is indicated on the rating plate on the reverse of the porthole door and on the rear side of the machine.

Technical features dry clothes washing capacity height width depth (piping included) total net weight motor water draining pump water heating element supply voltage power rating safety fuse water pressure

5 kg (11 lb) 850 mm (33 in) 595 mm (23.5 in) 530 mm (20.9 in) 62 kg (136 lb) approx 350-500 watt 25 watt 2500 watt 230..240 V - 50 Hz 2850 watt approx 13 A min. 0,1 Mpa (1 bar) max. 1 Mpa (10 bar)

max cotton/linen load:

Washing 5Kg

max delicates/synthetic load:

Washing 2,5Kg Drying 1,5Kg

Drying 2,5Kg

max wool load:

Washing 1Kg Drying -

INSTALLATION DIRECTIONS POSITIONING After your washing machine has been placed in the desired location, level it by means of the front left foot, them the COUNTERNUT NOT counternut must be blocked by means of the special key purposely provided. Warning: if the machine is not perfectly SUPPLIED ADJUSTABLE FEET leveled, it will be unstable, noisy and may lead to SOLID BLOCK