Aquabot Breeze XLS Pool Cleaner

820420

BREEZE XLS ROBOTIC POOL CLEANER SETTINGS AND TROUBLESHOOTING GUIDE

PLEASE READ CAREFULLY BEFORE USING YOUR POOL CLEANER

Aqua Products, Inc 282 Grove Avenue Cedar Grove, NJ 07009 United States

product settings and troubleshooting WARNINGS WARNING: Do not turn the Power Supply on, unless the pool cleaner is in the water. WARNING: Do not operate your machine while people swim in the pool. WARNING: The Power Supply must be placed at least 12 feet / 4 meters from the pool’s edge at all times! See diagram below. WARNING: To prevent possible electric shock hazard this unit must be connected to an RCD (Residual Current Device) with a related residual operating current not exceeding 30mA. WARNING: Before performing any troubleshooting maintenance procedures, your Cleaner should be disconnected from the Power Supply (transformer) and the Power Supply should be unplugged from the electrical outlet to prevent the possibility of personal injury or damage to your Cleaner!

PRODUCT SETTINGS POWER SUPPLY Setting up the power supply is simple. First, make sure that the power supply is plugged into a GFCI (Ground Fault Circuit Interrupter) outlet. Then lift the cover on the power supply outlet and connect plug on the floating cable into the power supply.

Midpoint of the Long side of Pool Power Supply 12ft / 4m

Cleaner

TIMER SETTINGS / POOL SIZE

To turn the power supply ON, press and release the power button once. To turn the power supply OFF, press and release the power button. Light will turn OFF

= 1 Hour Shut-off = 2 Hour Shut-off The power supply has 2 settings. Each setting is determined by the pool size and cleanliness as well as for how long you would like to run the cleaning cycle. You have an option for SMALL POOL and LARGE POOL. Press the SELECT button to get your correct setting

= 1 Hour Shut-off = 2 Hour Shut-off

product settings and troubleshooting

PRODUCT SETTINGS

To set the preferred turning radius move the slider either to the left or right . See the diagram below.

ADJUSTING THE AXLE Your cleaner moves about your pool by way of an adjustable axle. This adjustable axle is controlled by a slider that is located on the front of the cleaner. There are various positions that this slider can be set to. Each setting will affect how wide or tight the cleaner turns when running in it’s cleaning cycle. It is recommended that before every cleaning cycle you alternate the position so that the axle is cleaning the opposite way. This is so that your cleaner can reach all areas of the pool and hence, prevents the cable from tangling. Make sure the axles are freely moving and the axle channels are clear. The slider is factory set to the second setting from the center.

Direction of Power Supply

Direction of Cleaner

HOW TO USE THE E-Z SWIVEL TO HELP UNTANGLE FLOATING CABLE The E-Z Swivel is a feature that will help untangle the floating cable should this occur. To use the E-Z Swivel it is recommended that you stand outside of the pool. Make sure that the floating cable is disconnected from the power supply! Now grab the large part of the grip on the floating cable. Using one hand, pull towards the direction that is between you and the power supply and walk away from the cleaner. As you move further from the cleaner, the floating cable will untangle itself and straighten out.

NOTE: It is recommended that you turn OFF the power supply before entering the pool with the cleaner in the water.

Using E-Z Swivel while cleaner is OFF and still inside pool

Using E-Z Swivel while cleaner is OFF and outside pool

product settings and troubleshooting

PRODUCT SETTINGS RE-INSTALLING FILTER BASKETS AFTER CLEANING After you have cleaned the filter baskets, you’ll need to re-install them back into the cleaner. Make sure the channels on the basket are clear of any debris or they won’t close completely. Carefully slide them back into the cleaner so they are secure.

NOTE: This filter media MAY NOT be put into any washing machine or dryer. Make sure you rinse off any leaves, twigs and larger debris before re-installing.

product s